{"repo":"wodowiesel/PiFunk","free":true,"listed":false,"github":"https://github.com/wodowiesel/PiFunk","clone":"git clone https://github.com/wodowiesel/PiFunk.git","description":"PiFunk Radio Transmitter - with FM/AM-Modulation for HAM-Bands (CB 27 & PMR 446)","language":"C","stars":21,"topics":["radio","pmr","cb","frequency","fm","am","ham-radio","pi","raspberry-pi","wav"],"license":"GPL-3.0","category":"self-hosted-apps","readme_excerpt":"README PiFunk Radio Transmitter - with FM/AM-Modulation for HAM-Bands Early Experimental! (WIP - Work in Progress) Configurations 0. Download Linux-Pi-Distribution Raspbian Buster lastest (Full) = v4.19.97+ or use the extra provided imager and extract and load bootable image on SD-card via Rufus 1. Get this program: sudo apt-get install git via git or download it on the page as .tar.gz sudo git clone https://www.github.com/wodowiesel/PiFunk 2. Configurations To configure the Pi modules via menu (I2C, ALSA-Audio, UART etc.): sudo raspi-config - Not recommending to use w1-protocol at the beginning (i don't need it in my setup) Using w1-gpio sometimes needs a 4.7 - 10 kΩ pullup resistor connected on GPIO-Pin 1-Wire by default BCM4 setting needs to be activated in boot-config for additional autostart if you like to you can install wiringpi via sudo apt-get install wiringpi (if you have problems while transmission deactivate 1-wire config, default should be off!) 3. Adding parameters: Manually open with nano-editor: sudo nano /boot/config.txt (i provide one too) check/add lines: dtoverlay=i2c1-bcm2708 for Pi1, Pi4: 2711 for using I2C Bus dtoverlay=gpiopin=4,pullup=0 add pullup=1 or w1-gpio if needed dtoverlay=audio=on for bcm-alsa-audio required! optional: dtparam=spi=on for SPI support optional enable uart=1 for UART RX & TX remote control init uart baud=9600 data transmission rate for serial data dtoverlay=pps-gpio,gpiopin=18 for GPS-device pps (puls-per-second)-support Add PPS ","default_branch":null,"files":null,"tree":[],"storefront":"/r/wodowiesel","claimed":false,"request_supported":{"post":"https://gitbuyer.com/r/wodowiesel/PiFunk/request-supported","requests":0},"note":"indexed from public GitHub; nothing is for sale on this page. Clone it from GitHub. Paid listings live at /search."}